Printronix L1524 - Manual (Page 102)

3–62 Configuring the Printer
FILE EXISTS ENABLE
OVERWRITE The “Overwrite Files” menu
selection is set to Disable, and
you attempted to write to an
existing file in the flash file
system. Enable the “Overwrite
Files” menu selection.
Then, try the operation
again.
FILE SYS FULL ADD
FLASH The file to be stored in the flash
file system is too big for the
flash, even if you were to delete
files from the file system and
optimize the file system. Have your service pro-
vider add more DC flash
memory to the controller
board, then optimize the
flash file system. (Refer
to page 3–46.) Finally, try
the operation again.
FILE SYS FULL DELETE
FILES The file to be stored in the flash
file system would either:
exceed the available free
space in the file system; or
exceed the maximum number of
files (144) that the file system
can hold. Delete one or more files
from the flash file sys-
tem. Then, optimize the
flash file system. (Refer
to page 3–46.) Finally, try
the operation again.
FILE SYS FULL
OPTIMIZE&REBOOT
There is insufficient free space
in the flash file system to do the
requested operation, and there
are existing file(s) in the flash
file system that have been
marked for deletion. Optimize the flash file
system to delete the
marked files, freeing the
space they were
occupying. (Refer to
page 3–46.) Then, try
the operation again.
FILE SYS INVALID
OPTIMIZE&REBOOT
The flash file system is either
invalid (corrupt) or not present.
The cause can be either a
program error or a hardware
failure of the DC flash memory. Reboot the printer sever-
al times. If the message
persists, Contact service
provider.
FILE SYS WRITE CHECK
FLASH
One or more errors occurred
while the printer was writing a
file into the flash file system.
The printer has marked the
corrupt file for deletion. The
cause can be data that became
corrupted during download, or a
hardware failure of the DC flash
memory.
NOTE: Although the corrupt file
cannot be used, it still occupies
space in the flash file system. To
free this space, optimize the
flash file system. (Refer to page
3–46.) Optimize the flash file
system to delete any
marked files (refer to
page 3–46), then retry
the operation. (If you
were downloading
software, optimize the
flash file system, then
power off the printer and
download the software
again.)
If the message persists
after several tries,
contact service provider.