Panasonic 1200N - Manual (Page 140)

Upgrading Software Modifications
10-24 Centillion 1200N ATM Switch User Manual
NTP 297-8103-903
NETWORK Mode
Load the software from the Ether network server connected via the LAN card
mounted in the PCMCIA slot #1. The office data is loaded from the ATA cad
mounted in PCMCIA slot #0. Software is not saved.
Figure 10-28: NETWORK Mode
Procedure
1. Turn off the power of the ATM Switch.
2. Insert into PCMCIA slot #0 the ATA card containing the office data you wish
to continue to use and into PCMCIA slot #1 the LAN card connected to the
Ether network.
3. Turn on the power of the ATM Switch and start the boot monitor.
4. Set the IP address of the ATM Switch.
BOOT# SET local ***.***.***.***
5. Set the server's IP address and boot file name.
BOOT# SET server ***.***.***.*** *****.bootfiles
6. Set the IP address of the default router.
BOOT# SET route ***.***.***.***
7. Set the boot mode as follows:
BOOT# SET boot network
8. End the boot monitor.
BOOT# QUIT