Panasonic 1200N - Manual (Page 94)

Software Upgrading Basic Configuration and Setup
8-4 Centillion 1200N ATM Switch User Manual
NTP 297-8103-903
Optional Commands
SET iproute - Configures an IP route within the switch, usually for remote hosts
for network management, etc. Use this command when the network that you want
to connect to is either connected to an ATM port or an Ethernet port. For more
information, see the “SET iproute (Privileged Command)” section of the ATM
Switch Command Manual.
SET nms - If an NMS system is installed, this command allows up to 4 remote
NMS systems to be installed. Options for this command allow you to set
community name access and read/write privileges.
DIAGNOSIS all - Performs a self test on all the components within the switch.
This command takes a few minutes to execute and displays the results after
completion.
DISPLAY configuration all - Displays the current configuration defined
within the switch. There are a number of default settings predefined within the
switch. You may save time during configuration and setup by looking at the default
configuration and determining what items are already configured to the desired
setting.
Software Upgrading
See "Upgrading Software" on page 10-16 .