NEC PlasmaSync 42PD3 - Manual (Page 13)

P LASMA M ONITOR Ⅵ Ⅵ Ⅵ †
13
11
10
9
8
7
6
5
4
3
2
1
Setup Procedure
Determine the installation location
Installation of only the plasma monitor is not possible. Be sure to
use and install the plasma monitor in conjunction with a stand or
special unit.
CAUTION
DO NOT ATTEMPT TO INSTALL THE
PLASMA MONITOR.
Installing your plasma display must be done by a qualified tech-
nician. Contact your dealer for more information.
CAUTION
DO NOT USE THE RETRACTABLE FEET
FOR PURPOSE OF PERMANENT INSTAL-
LATION.
The retractable feet are for temporary use only and are not in-
tended for permanent installation.
CAUTION
MOVING OR INSTALLING THE PLASMA
MONITOR MUST BE DONE BY TWO OR
MORE PEOPLE.
Failure to follow this caution may result in injury if the plasma
monitor falls.
Important
Lay the protective sheet, which was wrapped around the plasma monitor
when it was packaged, beneath the plasma monitor so as not to scratch the
panel.
Install the plasma monitor
In setting up a multiple screen system, please give consideration
to the cable length and type since image quality may be degraded.
Install the remote control batteries
The remote control is powered by 1.5
V AA magnesium batteries.
To install or replace batteries:
¡ Press and slide to open the cover.
™ Align the batteries according to
the (+) and (–) indications inside
the case.
£ Replace the cover.
Connect external equipment (See page 14)
• To protect the connected equipment, turn off the main power
before making connections.
• Refer to your equipment user manual.
Connect the supplied power cable
• The power outlet socket should be installed as near to the equip-
ment as possible, and should be easily accessible.
• Attach the supplied ferrite core to the power cable. See page
50.
• Fully insert the prongs into the power outlet socket. Loose con-
nection may cause noise.
Switch on the power of all the attached external equipment
When connected with a computer, switch on the power of the com-
puter first.
Operate the attached external equipment.
Display the signal on the external equipment you wish.
Select the input mode (See pages 22 and 27)
Select the appropriate input.
When the equipment is connected to the RGB 2/DVD/HD, make
the setting for the RGB 2 input. Make the VIDEO settings when a
connection has been made to VIDEO. When an audio signal is
connected, make the setting for sound.
Adjust the sound (See page 27)
Make adjustments when adjustment of the volume or balance is
required.
Adjust the screen
(See pages 31 and 32)
Make adjustments when adjustment of the screen display position
or distortion is required.
Adjust the image (See page 28)
Make adjustments when picture adjustment such as the bright-
ness or contrast is required.