NEC PlasmaSync 42PD3 - Manual (Page 19)

P LASMA M ONITOR Ⅵ Ⅵ Ⅵ †
19
Connections
Connecting Your DVD Player
Connecting your DVD player to your Plasma monitor will enable you to display your DVD' s video.
Refer to your DVD player owner's manual for more information.
* When [CINEMA PULLDOWN] is set to [ON] with another function menu and the film recording software that has filmed the video in 24
frames per second (progressive) is played back, the plasma monitor fetches...3 frames, 2 frames and converts them into a 60 frames per
second progressive signal. (2-3 pulldown) Note that this is valid only for NTSC, PAL, and 480I (60 Hz) signals.
Connect the Plasma Monitor to a DVD Player
• To connect the RGB 2/DVD/HD IN connector (BNC) on the plasma monitor, use a separately available BNC connector cable. You will
need a separately available BNC-to-RCA adapter to connect a DVD player with an RCA pin jack to the BNC connector cable.
Some DVD players may have different connectors such as Y,Cb/Pb, and Cr/Pr.
Select [DVD/HD] for RGB 2 from the INPUT SELECT menu.
When connecting one or more Plasma monitors, use the RGB 2/DVD/HD OUT connectors (BNC).
• The AUDIO IN 1 and 2 (both RCA) can be both used for audio input. For connection, select [INPUT 1] or [INPUT 2] from the SOUND
menu.
AUDIO
OUT
LR
AUDIO
IN
2
L( MONO
)
R
VIDEO
OUT S -VIDEO
VIDEO
AUDIO I
N 1
EXTERNAL CONTROL
RGB 1
L (MONO
)
R
IN
IN
OUT IN
OUT IN
RGB 2
/DVD
/HD
G /Y
B /C
B /P
B
H /CS
V
R /C
R /P
R
REMOTE
RGB 3
IN
OUT
C /L
IN
Plasma monitor
Plasma monitor (second monitor)
BNC X3
BNC X3 BNC X3
RCA
BNC X3
BNC-to-RCA adapter
To
audio right output
To
audio left output
To DVD Component video output
To RGB 2/DVD/HD IN
DVD player