NEC PlasmaSync 42PD3 - Manual (Page 16)

16
Ⅵ Ⅵ Ⅵ † P LASMA M ONITOR
Connecting Your Macintosh Computer
Connecting your Macintosh computer to your Plasma monitor will enable you to display your
computer's screen image. Some video cards or drivers may not display images correctly. (See also "Signal Identification For Raster
Preset" on page 64.)
Connect the Plasma Monitor to Your Macintosh
• To connect the RGB 1 IN connector (mini D-sub 15 pin) on the plasma monitor, use the supplied RGB signal cable (mini D-sub 15 pin to
mini D-sub 15 pin).
For older Macintosh, use a pin adapter for Macintosh (available separately) to connect to your Macintosh's video port.
The resolution modes that you can select are:
• 13" fixed mode • 16" fixed mode • 19" fixed mode
• To connect the RGB 2/DVD/HD IN connector (BNC) on the plasma monitor, use the signal cable available separately (mini D-sub 15 pin
to BNC x 5).
Select [RGB] for [RGB 2] from the INPUT SELECT menu.
When connecting one or more Plasma monitors, use the RGB 2/DVD/HD OUT connector (BNC).
• If you use with a Macintosh PowerBook, set "Mirroring" to Off.
Refer to your Macintosh's owner's manual for more information about your computer's video output requirements and any special
identification or configuring your monitor's image and monitor may require.
• The AUDIO IN 1 and 2 (both RCA) can be both used for audio input. For connection, select [INPUT 1] or [INPUT 2] from the SOUND
menu.
AUDIO
OUT
LR
AUDIO
IN
2
L( MONO
)
R
VIDEO
OUT S-
V
ID
E O
VIDEO
AUDIO I
N 1
EXTERNAL CONTROL
RGB 1
L (MONO
)
R
IN
IN
O U T IN
OUT IN
RGB 2
/DVD
/HD
G /Y
B /C
B /P
B
H /CS
V
R /C
R /P
R
REMOTE
RGB 3
IN
O U T
C /L
IN
Plasma monitor
Plasma monitor (second monitor)
To
audio right output
To RGB 2/DVD/HD IN
BNC x 5
BNC x 5
RCA
Mini D-sub 15 pin
BNC x 5
Mini D-sub 15 pin
To video output port
Macintosh
To
audio left output
Connections
Pin adapter for
Macintosh