NEC PlasmaSync 42PD3 - Manual (Page 26)

26
Ⅵ Ⅵ Ⅵ † P LASMA M ONITOR
Configuration Menu (CONFIG MENU)
This menu sets the main menu, display of adjustment details, remote control, sync, and the brightness of the multiple system.
1 Align the cursor with the desired item
2
3
Move the cursor up and down with
the POSITION/CONTROL
▲▼
buttons.
OSD DISPLAY :NORMAL
OSD MODE
:BASIC
WIRELESS REMOTE
CONTROL :ON
SYNC MODE
:AUTO
PLE LINK :OFF
ALL RESET
CONFIG MENU
OSD DISPLAY :KEY
OSD MODE
:BASIC
WIRELESS REMOTE
CONTROL :ON
SYNC MODE
:AUTO
PLE LINK :OFF
ALL RESET
CONFIG MENU
Press the EXIT button one time to return to the config menu.
One further press removes the menu.
Adjust with the POSITION/CONTROL
ᮤ ᮣ buttons
Press the EXIT button 2 times
Adjustment Items
■ OSD DISPLAY
[NORMAL] : Displays the menu screen and adjustment details.
[KEY]
: Displays the adjustment details for only input switch-
ing and direct adjustments.
[OFF] : No display of any menu screens or adjustment details.
■ OSD MODE
[BASIC]
: Allows only the first page of the main menu to be displayed.
[PRO] : Allows Pages 1 and 2 of the main menu to be displayed.
■ WIRELESS REMOTE CONTROL
[ON]
: Enables remote control wireless transmission.
[OFF] : Disables remote control wireless transmission.
* This is normally left [ON]. Set [OFF] to avoid unwanted
control from other remote controls.
■ SYNC MODE
[AUTO]
: Automatically detects separate sync signals,
green sync signal (i.e., sync-on-green), and
composite sync signal.
[GSYNC] : Automatically detects green sync signal (i.e.,
sync-on-green).
[CSYNC] : Automatically detects composite sync signal.
■ PLE LINK
[ON]
: Sets a uniform screen brightness for each
screen in a 4-screen multiple system.
[OFF] : Sets the screen brightness for each of the
screens in a 4-screen or multiple system to their
respective brightness.
* Set [OFF] in a 9-screen multiple system.
* When this function is set [ON], connect four plasma moni-
tors with the remote control cable (included with the op-
tional remote control) in the order of the position numbers
for 4-screen multiple system. See the drawing below.
Preparation Simultaneously press and hold the POSITION/CONTROL ▲ button and the PROCEED button for 3 seconds or longer
to display the menu screen.
Note:
Please use the control panel of the main unit at this time since
operation with the remote control will not be enabled with this
arrangement.
REMOTE
IN
REMOTE
IN
REMOTE
OUT
REMOTE
OUT
REMOTE
IN
REMOTE
OUT
REMOTE
OUT
REMOTE
IN
No.1 No.2
No.3 No.4
No.1 No.2
No.3 No.4
No.1 No.2
No.3 No.4
No.1 No.2
No.3 No.4
Monitor Monitor
Monitor Monitor
■ ALL RESET
Align the cursor and then press the PROCEED button to
return all adjustments and settings of CONFIG MENU to the
factory default values.