NEC ExpressA1160 - Manual (Page 211)

DVD Drive (CRU)
11-15
Figure 11-12 DIMM Socket Release Latches
Replacing the Memory Board
1. Align the memory board with the bottom rails on the drive tray.
2. Lift the blue handle and push in the memory board.
3. Rotate the handle down to fully engage the board.
Replacing the Fan Module
1. Align the fan module in the cell, and push in the fan module until it is fully engaged.
2. Rotate the handle upward to lock the module in place.
The green status light illuminates to indicate that the fan module is running properly.
11.10. DVD Drive (CRU)
Use the following procedures to remove and replace the DVD drive.
11.10.1. Removing the DVD Drive
1. Press the locking slider plate on the bottom right side of the drive to disengage the
drive.
2. Using the plate, pull the drive out of the cell.