Nortel Networks NN43001-563 - Manual (Page 217)

Configure IP Trunk 3.01 (and later) data 217
Prompt Response Description
DNUM x Device Number for I/O ports, where:
x = 0 – 15
PORT x Port number for MSDL card, where:
x = 0 – 3
DES IP TRUNK 16 character designator is "IP TRUNK" Specific description
if more than one IP Trunk 3.01 (and later) route exists.
...
USR User.
ISLD Dedicated Mode ISDN Signaling Link.
IFC Interface type for D-channel:
SL1 Meridian Customer Defined Network (MCDN)
ESGF ESIG interface with GF platform (QSIG)
ISGF ISIG interface with GF platform (QSIG)
The ESGF and ISGF responses are allowed if the QSIG
and QSIG GF packages are both equipped.
The IFC entry must match the protocol entered in TM 3.1
(and later) Node Properties, Card Configuration, Protocol
pull-down menu.
ISLM xxx Integrated Service Signaling Link Maximum CHIDs,
where:
x = 1 – 382
ISLM is the maximum number of ISL trunks controlled by
the D-channel. There is no default value.
BPS (64000) 64000 is the default and is required for the IP Trunk 3.01
(and later) DCHIP.
PARM (RS422 DTE) The RS-422 parameters are established with switch
settings on the MSDL card. This prompt is used to verify
those settings prior to enabling the card.
RCAP Remote Capabilities
ND2 Network Name Display type 2 signaling. All nodes must
use same RCAP.
...
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.