Nortel Networks NN43001-563 - Manual (Page 232)

232 Install and configure IP Trunk 3.01 (and later) node
Use the following overlay tables to configure ESN, Route List Block with Step
Back on Congestion on ISDN, dialing plan, and Co-ordinated Dialing Plan.
LD 86 Configure Electronic Switched Network (ESN)
Prompt Response Description
REQ NEW Add new data.
CUST xx Customer number as defined in LD 15.
FEAT ESN Electronic Switched Network data block.
...
CDP YES Co-ordinated Dialing Plan
...
AC1 xx One-or-two digit NARS/BARS Access Code 1.
AC2 xx One-or-two digit NARS Access Code 2.
TGAR (NO) YES Check for Trunk Group Access Restrictions on ESN calls.
Set TGAR = YES if required to block non-fax modem
traffic from the IP Trunk 3.01 (and later) route.
Caution: This will impact all trunk access for ESN calls.
TGAR and TARG values must be carefully coordinated
for all stations, trunks, and routes when setting TGAR =
YES in the ESN block.
LD 86 Configure Route List Block with Step Back on Congestion on ISDN
Prompt Response Description
REQ NEW Add new data.
CUST xx Customer number as defined in LD 15.
FEAT RLB Route List Data Block.
RLI xxx Route List Index to be accessed, where xxx is:
0-127 for BARS
0-255 for NARS
0-999 for FNP
ENTR xx Entry number for NARS/BARS Route List, where xx is:
0-63 for BARS/NARS
...
ROUT Route number
0-511 Range for Large System, Call Server 1000E, and Media
Gateway 1000E
0-127 Range for Small System and Media Gateway 1000B.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.