Nortel Networks NN43001-563 - Manual (Page 461)

Install the RM356 modem router 461
3 Connect the RJ-45 plug end of the local manager cable to the
RS-232 Manager port RJ-45 jack on the rear of the modem router.
Connect the other end of the cable to an RS-232 terminal or PC
COM port configured for the following communication parameters:
• 9600 bps
• 8
• none
• 1
The local maintenance cable connects directly to data terminal
equipment (DTE).
4 The analog telephone line should be a CO line or a PBX extension
with a Direct Inward Dialing (DID) number if that is in compliance
with the customer’s network security policy.
—End—
Configure the TM 3.1 PC to communicate with a remote system site
through a modem router
If the customer’s version of TM 3.1 does not support the modem router
communication profile for Meridian 1/CS 1000M system types, work around
the limitation by configuring a Dial-up Networking (DUN) session under
Windows to connect to the modem router at a particular system site.
In the TM 3.1 Navigator, configure the system communication profile as
"Ethernet." Establish the Dial-up Networking session from Windows before
attempting to connect to the system from the TM 3.1 Navigator. IP Trunk
3.01 (and later) nodes on the same ELAN subnet are also accessible over
the same Dial-up Networking connection to the modem router.
Configure the RM356 modem router through the manager menu
Configuring the RM356 modem router by the manager menu can be
completed from a TTY or PC connected to the local RS-232 manager port
on the rear of the modem router. Alternatively, the manager menu can be
accessed by Telnet after the IP addressing and routing have been set up
initially from the local manager port.
The arrow keys navigate in the RM356 manager menu. The spacebar key
toggles pre-defined configuration values for a field. The Enter key saves
data changes to ROM and exits the current menu. The Esc key exits the
current menu without saving changes. Enter the menu selection number,
when prompted, to display a sub-menu, configuration form, or command
prompts.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.