Introduction, Preparing for the new installation – Reliance Water Heaters 606 User Manual

Page 5

Advertising
background image

Abbreviations Found In This Instruction Manual

CSA - Canadian Standards Association

ANSI - American National Standards Institute

NFPA - National Fire Protection Association

3. If after reading this manual you have any questions or

do not understand any portion of the instructions, call

the local gas utility or the manufacturer whose name

appears on the rating plate.

4. Carefully plan the place where you are going to put the

water heater. Correct combustion, vent action, and

intake air and exhaust vent pipe installation are very

important in preventing death from possible carbon

monoxide poisoning and fires.

Examine the location to ensure the water heater com-

plies with the “Locating the New Water Heater” section

in this manual.

5. For California installation this water heater must be braced,

anchored, or strapped to avoid falling or moving during

an earthquake. See instructions for correct installation pro-

cedures. Instructions may be obtained from your local

dealer, wholesaler, public utilities or California Office of

the State Architect, 400 P Street, Sacramento, CA 95814.

6. Massachusetts Code requires this water heater to be

installed in accordance with Massachusetts 248-CMR

2.00: State Plumbing Code and 248-CMR 5.00.

7. Complies with SCAQMD rule #1121 and districts having

equivalent NOx requirements.

Introduction

Thank You

for purchasing this water heater. When

installed according to State and Local Codes and main-

tained according to the manufacturers instructions, it should

give you years of trouble free service.

1. Read the “General Safety” section, pages 2 and 3 of this

manual first and then the entire manual carefully. If you

don’t follow the safety rules, the water heater will not

operate properly. It could cause DEATH, SERIOUS

BODILY INJURY AND/OR PROPERTY DAMAGE.

This manual contains instructions for the installation,

operation, and maintenance of the gas-fired water

heater. It also contains warnings through out the manu-

al that you must read and be aware of. All warnings and

all instructions are essential to the proper operation of

the water heater and your safety. Since we cannot put

everything on the first few pages, READ THE ENTIRE

MANUAL BEFORE ATTEMPTING TO INSTALL OR

OPERATE THE WATER HEATER.

2. The installation must conform with the instructions in this

manual; gas company rules; and Local Codes, or in the

absence of Local Codes, with the current edition of the

National Fuel Gas code, ANSI Z223.1, also referred to as

NFPA 54. This publication is available from your local

government or public library or gas company or by writ-

ing NFPA, Batterymarch Park, Quincy, MA 02269.

Preparing for the New Installation

5

WARNING

This gas-fired water heater is design certified by CSA

International under American National Standard/CSA

Standard for Gas Water Heaters, ANSI Z21.10.1 • CSA

4.1 (current edition). The installation must conform with

this manual, Local Codes and with the current edition

of the National Fuel Gas Code, ANSI Z223.1.

This publication is available from your local government

or public library, gas company, or by writing NFPA,

Batterymarch Park, Quincy, MA 02269.

Advertising
This manual is related to the following products: