Omega WI8XX-U - Manual (Page 12)

2.1.2 Rear Panel
The rear panel connections are shown in Figure 2.2.
Figure 2.2 Rear Panel Power and Output Connections
Table 2.2 Rear Panel Connector
POWER AC/DC Power Connector: All models
OUTPUT 1 Based on one of the following models:
Relay SPDT
Solid State Relay (SSR)
Pulse
Analog Output (Voltage and Current)
OUTPUT 2 Based on one of the following models:
Relay SPDT
Solid State Relay (SSR)
Pulse
Network Communication Interface Section:
ETHERNET RJ45 interface for 10BASE-T connection.
RESET Button: Used for power reseting the Ethernet board.
ACTIVITY LED (Red) Blinking: Indicates network activities (receiving or
sending packets).
NET LINK LED (Green) Solid: Indicates good network link.
TX LED (Yellow) Blinking: Indicates transmitting data to the serial port.
RX LED (Green) Blinking: Indicates receiving data on the serial port.
ACTIVITY
NET LINK
TX
RX
8 1
ETHERNET
RST
RJ45 10BASE-T
CONNECTION
RESET
BUTTON
LED
INDICATORS
ANTENNA
LOCATION
POWER
L(+) N(-)
1 6 OUTPUTS 7 8
7 8
NOT USED
SSR RELAY PULSE SSR RELAY PULSE ANALOG
8 7 6 5 4 3 2 1
OUTPUT 1 OUTPUT 1 OUTPUT 1 OUTPUT 1 OUTPUT 2 OUTPUT 2 OUTPUT 2
POWER / OUTPUT
CONNECTOR
6 5 4 3 2 1 3 2 1 3 2 1 6 5 4 6 5 4 6 5 4
NO NC
C
CUR
V
RTN PUL RTN
NO
C
NO NC
C
PUL RTN
NO
C
6
Use copper conductors
only for power connections