Omega WI8XX-U - Manual (Page 80)

74
PART 7
FACTORY PRESET VALUES
To set the Wireless and Ethernet settings back to Factory Default do the
following to the DIP switches (see Figure 2.11).
To set the Ethernet board to Factory Default settings:
1) Put the 4 position DIP switch #2 to ON position (it does not matter if the
Meter is On or Off).
2) Power-cycle the Meter and wait about 10 seconds until the Meter fully boots
up.
3) Put the DIP switch #2 back to OFF position (it does not matter if the Meter is
powered On or Off, just make sure that the DIP switch is set to OFF,
otherwise, everytime the unit is power-cycled the factory settings will take
over.
To set the Wireless board to Factory Default settings:
1) Put the 8 position DIP switch #1 to ON position (it does not matter if the
Meter is On or Off).
2) Power-cycle the Meter and wait about 10 seconds until the Meter fully boots
up.
3) Put the DIP switch #1 back to OFF position (it does not matter if the Meter is
powered On or Off, just make sure that the DIP switch is set to OFF,
otherwise, everytime the unit is power-cycled the factory settings will take
over.
The defaults that will change are noted by a "W" or "E" in the Table
below. The defaults for the Meter/Controller "C" are set by the individual
Setup menus.
C = Meter/Controller Board
W = Wireless or Coordinator Board
E = Ethernet or iServer Board
Table 7.1 Factory Preset Values
CONTROLLER SETUP
Input
Control End Device ID 1 W
Filter 4 C
Temperature Unit F C