Omega WI8XX-U - Manual (Page 14)

2.1.4 Assembly and Mounting
2.1.4.1 Panel Mounting Instruction
1. Using the dimensions from the panel cutout in Figure 2.3, cut an opening in
the panel.
2. Remove sleeve from the rear of the case by removing thumbnuts.
3. Insert the case into the opening from the front of the panel, so the gasket seals
between the bezel and the front of the panel.
4. Slip the sleeve over the rear of the case.
5. Tighten the thumbnuts to hold the unit firmly in the panel.
Figure 2.4 Panel Mounting
Front Bezel
Gasket
Case
Panel
Thumbnuts
Sleeve
Model No.
Label
8