Omega WI8XX-U - Manual (Page 58)

52
4.3.9 End Device Setup (continued)
The End Device Setup Page is for configuring the End Device parameters such
as Name and Update Rate.
#: End Device ID/address configured on the End Device. Click on the number
(1 to 8) to view device and modify End Device Parameters.
Name: Name of an End Device, shows on the "Readings" and "Chart" pages.
It is modified on the "End Device Parameters" page.
Update: How often the Meter is expected to receive data from an End Device.
It is modified on the "End Device Parameters" page.
Network: Each check box controls whether or not readings from the End Device
will be outputted.
If unchecked, the reading from the End Device will not be displayed on the
"Readings" and "Chart" pages nor it will be reported through Telnet.
Each End Device has two boxes assigned: the first is for the process sensor, and
the second is for the ambient sensor.
Units: Type of data and the corresponding units [ºC or ºF].
Units of measurement from sensors inside an End Device that has joined the
network will be displayed.
It is modified on the Controller Setup "Input" page.
Remote Format: Modified on the "End Device Parameters" page.
End Char: Modified on the "End Device Parameters" page.
Display: Modified on the "End Device Parameters" page.
Alarm: Modified on the "End Device Parameters" page.
Update: After checking/unchecking the boxes, make sure this is clicked to save
the changes.
Readings: This will take you to the "Readings" page.
Chart: This will take you to the "Chart" page.
4.3.9.1 End Device Parameters
Device Name: Name of this End Device, this is a text field and can take up to
16 alphanumeric characters.