Omega WI8XX-U - Manual (Page 54)

48
4.3.7.6 Passcode ID
To prevent unauthorized tampering with the setup parameters, the Meter
provides protection by requiring the user to enter the ID Code before allowing
access to subsequent menus of the Meter’s front panel. If the ID Code entered
does not match the ID Code stored, the Meter responds with an error message
and access to subsequent menus will be denied.
Setpoint ID: If enabled, ID Code is set to Setpoint ID Security Level and if a
user attempts to enter the Configuration Menu, using the Front Panel Buttons,
they will be prompted to enter an ID Code.
Full ID: If enabled, ID Code is set to Full Security Level and if a user attempts to
enter the Main Menu, using the Front Panel Buttons, they will be prompted to
enter an ID Code.
ID: editable box to enter the 4 digit ID Code. Default is 0000.
Figure 4.20 ID Code
Setpoint ID
Disabled
Full ID
Disabled
ID
0000
Main Menu
SETUP
Passcode ID
SETUP
http://192.168.1.200
Address
Cancel
Update