Onkyo CDR-201A - Manual (Page 26)

26
Analog recording
Perform analog recording to record the signal input
to the analog input terminal of the CDR-201A. The
recording level can be adjusted manually.
Preparation
• Turn on the CDR-201A (see page 20).
• Place a recordable CD-R or CD-RW in the CDR-
201A (see page 20).
• Verify that the input dial and recording selection
button of the amplifier are set to the position of
the recording source.
1
Repeatedly press the INPUT button
until "Analog In" appears.
Proceed to step 3 if you do not wish to adjust
the recording level.
2
Start playback of the recording source.
3
Press the o REC button (or the remote
controller REC o button).
The level sync function turns on.
"Rec Setup" appears in the display followed by
the time display (the recording standby state).
4
Adjust the recording level
Refer to page 24, step 4 "Adjust the recording
level."
5
Stop playback of the recording source.
6
Press the n button (or the remote
controller s button) and start the
recording source.
Recording starts. If the entire disc becomes filled
with recordings, the CDR-201A automatically
stops.
To set the track numbers manually
Press the o REC button.
To pause the recording
Press the n button (or the remote controller g
button). To resume recording, press the n button
(or the remote controller s button) when the time
display appears.
The CD recorder will stop, if the recording standby
state persists for 10 minutes or more.
To stop the recording
Press the e button.
AUDIO CD RECORDER
DISPLAY
STANDBY / ON
STANDBY
INPUT CD DUBBING REC FINALIZE EDIT / NO YES
PUSH TO ENTER
MULTI JOG
CDR-201A
STANDBY/ ON OPEN / CLOSE
RANDOM MEMORY REPEAT
NAME ABC DEF
2 3 1
SCROLL GHI MNO J K L
4 5 6
CLEAR
DISPLAY ENTER
PQRS TUV W XYZ
10/0 >10
7 8 9
REC
RC-448C
INPUT
o REC s
EDIT/NO
n
YES
o REC
Proceed to step 6 if you do not wish to adjust
the recording level.
º
INPUT
REC REC
CDR-201A RC-448C