Onkyo CDR-201A - Manual (Page 49)

49
Other Information
Troubleshooting guide
Messages during recording (continued)
Display Cause Remedy
CD Dub Fail CD dubbing cannot be performed because Select "Digital In 1" for the input source.
"Digital In 1" is not selected for the input source.
CD dubbing cannot be performed because Cancel the recording or recording standby state on
the connected component (Onkyo separate the connected component.
collection's cassette deck or MD recorder)
is in the recording or recording standby state.
CD dubbing cannot be performed because Make sure that proper connections is made for
the components are not properly connected. the z cable, audio connection cables, and optical
digital cable.
Cannot Rec Recording cannot be performed because Replace it with a non-finalized CD-R.
a finalized CD-R is used.
Recording cannot be performed because Replace it with a non-finalized CD-RW. Or, retry
a finalized CD-RW is used. recording after unfinalizing it.
Messages during playback, name input, and other situations
Display Cause Remedy
Blank Disc You have tried to play a disc that has If the inserted disc is a CD-R or CD-RW
no recordings on it. with no recordings, you may record onto it,
but it cannot be played.
No Disc No disc has been inserted. Open the disc tray and make sure that a
disc is inserted.
Name Full Entering name information exceeding the You can enter up to 1000 characters per disc
limitation of 1000 characters per disc was (see page 34).
attempted.
Full Entering a name exceeding the limitation of You can enter up to 24 characters per name
24 characters per name was attempted. (see page 34).
Memory Full Programming more than 32 tracks was You can program up to 32 tracks.
attempted.
Cannot Edit • Editing of a CD or finalized CD-R was attempted.
• Editing of a finalized CD-RW was attempted while
• Exit the memory or random playback mode.
in the memory or random playback mode.
• Editing of the name of a finalized CD-RW was • To edit the disc name, first unfinalize the disc.
attempted using the remote controller.
DAO Disc Unfinalizing a disc recorded with the DAO Unfinalization cannot be performed using the CDR-
method (*2) using a computer was attempted. 201A.
Not Audio A signal that cannot be recorded is being input. Input only recordable audio signals (see page 18).
Data Disc One or more data tracks exist on the disc. Insert a disc that is suitable for recording.
PCA Full Since no PCA (*3) remains, no more tracks can Insert a disc that is suitable for recording.
be added.
PMA Full Since no PMA remains, no more tracks can be Insert a disc that is suitable for recording.
added.
*1 OPC (Optimum Power Control)/*3 PCA (Power Calibration Area)
If an unfinalized disc is inserted into the CDR-201A, experimental recording is performed in a specified area
on the disc to calculate the optimum laser power. This process is called OPC and the area for the
experimental recording is called the PCA.
*2 DAO (Disc At Once)
One type of recording method. Additional tracks cannot be added when this method is used.