TOA Electronics CP-66 - Manual (Page 39)

Paging during Normal Calls
This function allows a paging call to be made during the
conversation to call the third party and ask him if he
accepts the call, while holding the original conversation.
The original call, if he accepts, is transferred to the third
party.
When it is desirable to call the third party during the
conversation, press
plus the desired paging zone.
(0~7, 00~31, *00~15). This place the conversation on
hold and allows a paging call to be made.
Wait for a paging response by pressing . (The
original conversation is restored.) When there is the paging
response, the conversation is interrupted and the paging
party is automatically connected to the third party, while
transmitting a holding tone to the conversation partner.
Dial again when coming back to the original conver-
sation. To transfer the original call to the third party,
press or replace the handset.
* When the exchange in use is EX-610 or EX-620.
Note.
This function can be operated when both "Call Trans-
fer" and "Paging" functions are employed.
Group Hunting
Notes.
1. To use this function, No.200 programing must be
established for station a call is to be rerouted to.
Also set the DIP switch for Group Hunting to ON.
2. If all stations are registered for this function by
No.200 programing so that an imcoming call may
make a loop in the group, any incoming call is auto-
matically transferred to an idle station.
Conversation
Calling party Called party
Station paging
On hold
External PA paging
Resuming
the original call
When the called is busy, the call is automatically rerouted
to the pre-programed.
When that station is also busy, the call is further rerouted
to the other pre-programed station.
— 34 —