TOA Electronics CP-66 - Manual (Page 80)

Continuous Calling Tone
When there is an incoming call to the specified station,
a calling tone is sounded continuously at the called station.
The continuous calling tone stops if the called party presses
(except key)
1. Use this function when it is difficult to hear a brief
single tone due to high background noise. Any station
can be so made as to be called by the continuous calling
tone, but No.200 programming is required for such a
station (refer to Installation Handbook for EXES-6000
CP-66).
2. If the calling party presses the key while the
continuous calling tone is being sounded, the continuous
calling tone stops to allow the caller's voice call to go
through. Releasing the
key restores the conti-
nuous calling tone.
3. If either party continuously presses the key
during the normal two-way conversion, this makes a
one-way conversation from the party who pressed the
key. Releasing the key reverses the one-
way conversation flow and the other party has a domin-
ance (Press-to-Talk).
Notes.
1. In the NP type system that has no Privacy function,
the station can be called by the continuous calling
tone if its Privacy switch is set to ON. This function
by No.200 programming is, therefore, used in the PV
type system having the Privacy function or for the
HF-670M industrial type station equipped with no
Privacy switch.
2. The following stations can be called by the continu-
ous calling tone:
(1) Stations in the "NP" type system or specified
substations in the "PV" type system.
(2) Stations registered for continuous calling tone by
No.200 programming.
Continuous calling tone
Continuous calling call
(Any key other than
< Station vs. calling tone >
"PV" Type
"NP" Type
Non-programmed station (standard)
Programmed station
Handset programmed station
Non-programmed station (standard)
Programmed station
Responding to a call made by continuous calling tone
Single "trill" calling tone
(Call is put through immediately
after calling tone)
Continuous calling tone
-
Single "trill" calling tone
(Call is put through immediately after
calling tone)
Continuous calling tone
Depress any dial key other than
key.
Privacy tone
Privacy tone
Continuous calling tone
Continuous calling tone
Continuous calling tone
1 . Depress only dial key other than
key.
2. Pick up a handset.
3. Shift Privacy switch to OFF.
Tie-line
Continuous calling tone
Call
Type of calling tone
Privacy switch in OFF position Privacy switch in ON position
Type of system
Type of station
(Specific station provided with
"continuous calling tone" function by
station No.200 programming)
—74—