TOA Electronics CP-66 - Manual (Page 82)

Call Transfer
Call Transfer from Called Station Call
During the conversation, first dial
(the Station Number of the person the call is to be trans-
ferred to).
The original call is then held and the holding tone is trans-
mitted to the other party, while the third party is called
and asked whether he will accept the call. If he agrees to
accept the call, dial
or hang up a handset,
and the transfer will be completed.
This function allows called party to transfer that call to
another station. The party to whom the call is to be trans-
ferred, may be called using either the Station Number, the
Personal Number or through Single Digit Dialing.
Call Hold and Call Back from Calling or Called Station
During the conversation, first dial
(Station Number of the third party.)
The other party is then placed on hold while the third party
is called. Upon completion of the conversation with the
third party,
dial
or the third party dials
or the third party replaces a handset.
This allows the original conversation to resume.
Called Station Calling Station
Called Station
Transfered Station Number
Called Station Calling Station
Call
Holding
Third Party
Transfer
Called Station Called Station Calling Station
Call
The Transfer function is combined with the Call Holding
function.
When two parties are talking, either one can be temporarily
placed on hold to permit the call to another station. When
the conversation with the third party is over, the original
conversation can be resumed.
The third party can be called using either the Station Num-
ber, his Personal Number or through Single Digit Dialing.
Note.
When 2 or 3 exchanges are connected by tie-line, an
original call can be transferred only to the third party
who shares the same exchange with the party who trans-
fers the call.
Calling Station
Third Party
Tie-line
Called Station Third Party
Call Back Original Call
Called Station
Third Party
—76—