Tascam HS-4000 - Manual (Page 21)

TASCAM HS-4000
21
3 − Preparation
Inserting and removing CF cards
Inserting CF cards
Insert a CF card into CF card SLOT 1 or SLOT 2 on the front panel
of the unit in order to use it for recording and playback.
NOTE
CF cards can be inserted whether the power is ON or OFF.
1. Pull the CF card slot cover forward to open it.
2. Insert the CF card with the correct orientation.
With the labeled side up, insert the end with the connector
completely.
3. Close the cover.
NOTE
If you cannot close the slot cover, remove the CF card once, press the square
button to the right of the slot and then reinsert the card.
Removing CF cards
Turn the unit power OFF or stop operations before removing a
CF card.
CAUTION
Never remove a CF card during recording, playback or any other operation
that accesses the CF card. Doing so could, for example, cause recording errors,
loss of recorded data, and sudden loud noises to be output through
monitoring equipment, which could result in damaged equipment and
hearing loss.
1. Pull the CF card slot cover forward to open it.
2. Press the square button to the right of the CF card
slot to bring the button out.
3. Press the square button in again to partially eject the
CF card.
4. Pull the CF card out by hand.
Security screws
The included security screws can be used to lock the CF card slot
covers.
Use a Phillips head screwdriver to install or remove the screws.