Tascam HS-4000 - Manual (Page 27)

TASCAM HS-4000
27
4 – Basic operation
Formatting a CF card
CAUTION
・ Formatting a CF card erases all the data on it.
・ Always format CF cards with this unit before using them in it. If a CF card
that has been formatted by another device or PC is used, operation
might be affected.
7. Press the MENU key on the front panel to open the
MENU screen.
8. Touch the CF MANAGE button to open the CF MANAGE
screen.
9. Touch the QUICK button next to the FORMAT item.
The following pop-up message appears.
NOTE
If no CF card is inserted in that slot, the following pop-up message
appears.
10. Click the OK button in the pop-up window. A
reconfirmation pop-up window appears.
11. Touch the OK button on the pop-up message. During
formatting, the following pop-up message appears.
When formatting completes, the following pop-up message
appears.
12. Touch the OK button on the pop-up message. The
CREATE PROJECT screen automatically opens.
To make a new project, follow the procedures starting with
step 2 in the following “Creating a new project” section.
Creating a project automatically after quick
formatting
If you press the QUICK & Create Project button instead of
the QUICK button next to the FORMAT item, a new project will
be created after the CF card is quick-formatted.
When doing this, however, you cannot change the project
settings. The new project will be created with the same settings
as the current project.
1. Press the MENU key on the front panel to open the
MENU
screen. Then, touch the CF MANAGE button on the MENU
screen to open the CF MANAGE screen.
2. Touch the Quick & Create Project button next to the
FORMAT item. The following pop-up window message
appears.
This window shows the project name, session name,
sampling frequency, bit rate, frame type and number of
tracks in the project to be created.