Tascam HS-4000 - Manual (Page 70)

70
TASCAM HS-4000
9 – Playlist mode
Selecting the current player
When in dual player mode, set which player the controls on the
front panel affect.
1. Press the HOME key on the front panel to open the
Home Screen.
Dual player Home Screen
2. Touch the SELECT button for the player that you
want to select.
The background of the selected player becomes yellow.
Dual player Home Screen with player B selected
Setting the online function
When a player is selected, press the ONLINE key on the front
panel to set whether or not the sound from that player is output
through the output connectors.
Refer to “Online functions” on page 89 for details about making
settings for the online outputs.
NOTE
You cannot turn this function on or off for a player that is not selected. Select
the player first and then press the ONLINE key to turn this function on/off for
it.
Playback control in playlist mode
Press the PLAY key to start playback.
Press the PAUSE key to pause playback.
Press the PLAY key again to resume playback.
Press the STOP (RETAKE) key to stop playback.
Press the
. [MARK.] key or / [MARK/] key to
switch entries.
Press and hold the
m [ ] or , [ ] key to search
backward or forward.
Press the
. [MARK.] or / [MARK/] key while
pressing and holding the SHIFT key to move between marks.
Press and hold the
m [ ] key or , [ ] key while
pressing and holding the SHIFT key to search at high-speed.
NOTE
・ On the PLAY SETUP screen, you can set whether only the currently
selected entry is played or whether all the entries within the current
playlist are played. You can also enable and disable repeat playback.
(See “Playback settings (PLAY SETUP)” on page 73.)
・ Playback functions can also be used via parallel control.
Using the call function in playlist mode
Press the CALL (CHASE) key to locate to the point where
playback was last started from playback standby (call point) and
put the unit in playback standby mode.
BWF–J cue point
When the Follow BWF–J item is set to ON, during playback if a
BWF–J cue point is detected, the following corresponding
operation will occur. In addition, if the BWF–J Tally Out item is set
to ON and the unit is in single player mode, in response to each
BWF–J cue point, the CUE signal and tally signal will be output
rom the parallel remote connector. f
BC$STANDBY During entry selection, this point is used
as the playback start point. During
playback, playback pauses when this
point is reached. In either case, a
BC$STANDBY tally is output.
BC$CM During playback, when this point is
reached, a BC$CM CUE signal is output.
BC$END During playback, when this point is
reached, a BC$END CUE signal is output.
BC$STOP During playback, when this point is
reached, a BC$STOP CUE signal is output,
and playback stops.
BC$FILE During playback, when this point is
reached, a BC$END CUE signal is output. If
the beginning of a following take
(BC$STANDBY CUE point) exists, that CUE
will be followed.
BC$PAUSE During playback, when this point is
reached, a BC$PAUSE tally is output, and
playback pauses.
Using the flash start function in playlist
mode
Using a TASCAM RC–HS32PD (sold separately) or other remote
controller, flash start playback is possible.
For details, see “Flash start function” on page 90.