Trimble Outdoors AgGPS 332 - Manual (Page 36)

3 Connecting the Receiver
2 6 AgGPS 332 GPS Receiver User Guide
Note – If you use machine screws, tap the mounting holes to fasten the
receiver to the mounting surface. Trimble recommends that you use 8-32
UNF socket head cap screws. Alternatively, use self-tapping screws.
30.1
The antenna
Mount the antenna where it is safe from damage during normal
operation.
3.1
Routing and Connecting the Antenna Cable
A 5.5 m (18 ft) antenna cable (P/N 32608) is included with the receiver.
See Figure 3.3. One end of the antenna cable features a right-angle
connector. The opposite end features a straight connector. Connect the
right-angle connector to the antenna; then route the cable to the
receiver.
Figure 3.3 Antenna cable connections
Antenna cable
P/N 32608
Antenna cable
P/N 32608
SPOT antenna or Z+ antenna