Trimble Outdoors AgGPS 332 - Manual (Page 38)

3 Connecting the Receiver
2 8 AgGPS 332 GPS Receiver User Guide
Figure 3.4 shows how to connect the receiver to an external device
using the 5.5 m (18 ft) standard power/data cable.
Figure 3.4 Standard power/data cable connections
Plug the:
• right-angle connector into the receiver
• straight 9-pin connector into the external device
When routing the cable from the receiver to the external device, avoid
the hazards listed on page 27.
When the cable is safely routed and connected to the receiver, use
tie-wraps to secure it at several points, particularly near the base of the
receiver to prevent straining the connection. Coil any slack cable,
secure it with a tie-wrap and tuck it into a safe place.
+
-
Ground -ve Black
9-pin port
Connect cable
Connect antenna
cable to coaxial connection
P/N 30945 to Port A
Power +ve Red