Problems with the flashloader200 utility – Trimble Outdoors AgGPS 332 User Manual
Page 75
AgGPS 332 GPS Receiver User Guide 65
Troubleshooting 6
6.1
Problems with the FlashLoader200 Utility
Problem
Possible solution
The FlashLoader 200 utility cannot detect the
receiver or download the firmware.
Make sure that:
• Other programs, such as Microsoft
ActiveSync technology, are not using the
COM port that the computer is using.
• The receiver is connected to a 12–32 V DC
power source.
• All cables are connected correctly between
the device and the computer.
• The receiver is connected to the correct
computer COM port. To do this:
1. From the FlashLoader200 menu, select
Settings.
2. Select the check box for a serial link.
3. At Port, select Auto. Click
OK
.
4. Select the Upload firmware to receiver
check box.
5. Navigate to where the firmware file is
saved and select the file. Click
Proceed
.
6. From the Auto Port Select dialog, select
Use receiver on port... and click
OK
.
Once you have checked this, turn off the
receiver then turn it on again. Try again to
connect the FlashLoader200 utility.