Trimble Outdoors AgGPS 332 - Manual (Page 60)

5 Configuring the Receiver
5 0 AgGPS 332 GPS Receiver User Guide
5.1
Configuring the AgGPS Receiver to Operate in
RTK Mode
To configure the receiver in RTK mode:
1. From the Home screen, select Configuration / DGPS Config.
2. Set the Source Select field to RTK.
3. Press 4 then 5 to complete this part of the procedure.
4. For RTK operation, connect the radio to a port. Change the port
input settings for that port to RtkLnk.
5.1
Configuring the Communication Ports
If the receiver is to be connected to an external device, configure
Ports A and B so that the proper data type is input to and output from
the receiver.
To configure Port A:
1. From the Home screen, select Configuration / Port A Config.
2. Use the menu commands to configure the communication
ports. Ensure that the receiver outputs the correct GPS position
data type for the hardware device or software program that is
connected to the receiver.
To configure Port B:
• Repeat the above steps but in Step 1 select Configuration / Port B
Config.
To configure Port C:
• Repeat the above steps but in Step 1 select Configuration / Port C
Config.