Trimble Outdoors AgGPS 332 - Manual (Page 59)

AgGPS 332 GPS Receiver User Guide 49
Configuring the Receiver 5
To enable WAAS reception in the field:
1. Take the receiver outside. Make sure that it has a clear southeast
and southwest view of the sky.
2. Turn on the receiver. WAAS activation can take two or more
minutes. Once activation succeeds, the Home screen displays
D/3D :
5.1
Configuring the AgGPS Receiver to Operate in
Beacon Mode
To configure the receiver in Beacon mode:
1. From the Home screen, select Configuration / DGPS Config.
2. Set the Source Select field to Beacon.
3. Press 4 then 5 to complete this part of the procedure.