Trimble Outdoors AgGPS 332 - Manual (Page 63)

AgGPS 332 GPS Receiver User Guide 53
Configuring the Receiver 5
Changing the input or output port settings
1. From the Port A Config screen, press 2 until the Port-A
Input/Output screen appears.
2. Press 3 to activate the cursor.
3. Press 1 or 2 to change the value.
4. Press 3 .
5. Repeat Step 3 through Step 4 until you have set all the required
values.
6. Press 4 to save all the changes.
7. Press 2 to move to the next screen.
NMEA settings
Three screens (NMEA1, NMEA2, and NMEA3) show what NMEA
messages are output from the port. Message types shown in upper case
are being output; message types shown in lower case are not.
For more information about NMEA message types, refer to the
document called NMEA-0183 Messages Guide for AgGPS Receivers on
the Trimble website (
www.trimble.com).
Port output rate
This setting can be used to vary the NMEA and TSIP output rate. A
setting of 1 outputs one position each second.
ASAP equals the rate selected on the Position Rate screen under the
GPS Config menu. A setting of ASAP outputs positions five or ten times
every second. The default ( factory) setting is 1 Hz.
To change the receiver configuration settings, enter the Port Config
screens under the configuration menus.