Tandberg Data 3000MXP - Manual (Page 102)

TANDBERG 3000 MXP User Manual
98
Using the three last profiles you can enter the name of a profile, prefix and network selection.
This is useful if you have a fixed prefix for your service provider.
4.8.4 Data Port
The system provides two standard RS232 serial ports to allow a computer to be connected for
data transfer and control purposes. Note that when connecting to a PC the connecting cable
must be a straight through RS232 cable.
Baud Rate, Parity, Databits and Stopbits
If you wish to connect a PC to Data port 1, you must ensure that the PC and the system are
identically configured. The available settings are:
Baud Rate
Parity
Databits
Stopbits
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
None, Odd, Even
7, 8
1, 2
Mode
Data port 1 supports 3 different modes:
Data Provides a transparent data channel. This channel can be used for many
different purposes such as file transfer, application sharing and more. When
using this mode, it is necessary to have a TANDBERG system at the far end.
Control The control interface provided by the data port supports a subset of the
Hayes command set as well as a comprehensive set of system specific
commands. This mode maintains communication with the data port
’
s
command interpreter at all times. All features available from the hand-held
remote control can be accessed through the data port.
Modem Allows you to control the system externally via a PC as in Control Mode.
Once a call is established, Data port 1 will automatically switch to Data
mode. When the call disconnects, Data port 1 switches back to Control
Mode.