Tandberg Data 3000MXP - Manual (Page 19)

2 Installation
15
6. Screen Settings
When using wide screen (16:9) monitors, set TV Monitor Format to Wide (16:9).
TANDBERG also recommends setting Picture Layout to Picture outside Picture
when using 16:9 monitors. Picture outside Picture provides a display layout
optimized for wide screen monitors. The display layout may be changed at any
time using the Layout button on the remote control.
7. Software Options
To activate MultiSite and/or Presenter and bandwidth, you must enter a new
option key in the Software Options menu (see paperwork accompanying your
system). For more information on these options, contact your TANDBERG
representative.
8. Save changes
Remember to save any changes you make in a menu by selecting the Save
button on the Menu line and pressing OK.
Network configuration:
1. Open the Network menu
Open the Administrator Settings menu and choose Network.
2. ISDN configuration
Set Current Network to the network you want to use. Specify the settings for the
selected network in the relevant menu. For details, follow the instructions in
chapter 4.8.1 ISDN-BRI Settings. See also the examples:
a. Appendix 1: Connecting the system to ISDN using NT1 network adapters
b.
Appendix 2: Connecting the system to the Switched 56 network
3. LAN configuration
In the Administrator Settings menu, choose Network and LAN Settings. Specify
the necessary LAN settings according to the instructions from your LAN
administrator. For details, follow the instructions in chapter 4.8.2 LAN Settings. If
there is an H.323 Gatekeeper present on your LAN, see also chapter 4.8.2.2
H.323 Settings.
4. Save changes
Remember to save any changes you make in a menu by selecting the Save
button on the Menu line and pressing OK.