Tandberg Data 3000MXP - Manual (Page 97)

4 Administrator Settings
93
Sending Complete
On The system will send the ISDN message information element Sending Complete.
Off The system will not send Sending Complete.
4.8.2 LAN Settings
LAN Settings contain:

IP Settings

H.323 Settings

SNMP Settings
4.8.2.1 IP Settings
Remember to restart the system after making changes to IP Settings. Changes in IP Settings
menu will not have any effect before the system is restarted.
IP-assignment
DHCP (Dynamic Host Configuration Protocol) can be selected when a DHCP server is
present.
DHCP IP-address, IP-subnet mask and Gateway are not used because the DHCP
server assigns these parameters.
Static The system
’
s IP-address, IP-subnet mask and Gateway must be specified in the
IP-address field.
IP-address
IP-address defines the network address of the codec. This address is only used in static
mode. In DHCP-mode, the assigned IP-address can be found on the Welcome Menu.
IP-subnet mask
IP-subnet mask defines the type of network. This address is only used in static mode. Your
LAN-administrator will provide the correct value for this field.
Gateway
When using DHCP, the default gateway will be set automatically. If the LAN utilizes static IP
addresses, IP address, subnet mask, and default gateway must be specified by the LAN
administrator.