Tandberg Data 3000MXP - Manual (Page 94)

TANDBERG 3000 MXP User Manual
90
On The system will only send and receive encrypted data. The call will not be
established if not all participants support encryption.
Off The system will not send or receive encrypted data.
Technical encryption information like encryption algorithm and encryption check code can be
found in the Call Status menu.
4.7.2 Encryption Mode
Auto
The system will try to use the most secure encryption - AES, dependent on the
capabilities of the other sites. If all the other sites do not support AES-
encryption, DES encryption will be tried.
AES The system will try to use AES with 128 bits encryption when setting up calls. If
AES is not supported by the other site(s), no other type of encryption will be
initiated.
DES The system will always try to set up the call using DES with 56 bits encryption on
ISDN and IP. If all other sites do not support DES, no other type of encryption
will be initiated.
Both AES and DES Encryption are supported for mixed ISDN/IP calls. In addition AES -and
DES Encrypted sites can be connected at the same time.
4.7.3 Passwords
Administrator Password, IP Access Password, Streaming Password, VNC Password and
Access Code are duplicated from their respective menus. Using the Security menu gives you
a quick way to change all passwords of the system.