Tandberg Data 3000MXP - Manual (Page 111)

5 Peripheral Equipment
107
5.1 Interfaces
5 Video Inputs

1 video input used by the camera.

1 video input supporting S-Video through a Mini-DIN connector.

2 video inputs supporting composite signals through RCA connectors.

1 VGA/DVI-I (DVI = Digital Video Interface, I = Integrated Digital & Analog) input
supporting resolutions VGA (640x480), SVGA (800x600), XGA (1024x768) and
SXGA (1280x1024), analog or digital.
The system will automatically adapt to a PAL or NTSC input.
4 Video Outputs

1 S-Video output, Mini-DIN connector.

2 composite video outputs, RCA connectors.

1 VGA/DVI-I (DVI = Digital Video Interface, I = Integrated Digital & Analog) output
supporting resolutions SVGA (800x600) and XGA (1024x768, analog or digital.
The first Mini-DIN connector and the first RCA connector provide main video
(incoming/outgoing video and menus).
The other connector provide selfview/still image/Duo Video. The outputs are always active.
The format of the output will be either PAL or NTSC depending on your country
’
s standard
video format.
The VGA/DVI output provides either main monitor video or second monitor video depending
on menu configuration.
VGA formats supported on 'DVI-I out':
SVGA (800x600) 75 Hz
XGA (1024x768) 60 Hz
4 Audio Inputs

2 microphone inputs (balanced, 11V phantom powered) via XLR connectors.

2 audio inputs (line level) via RCA connectors.
All audio inputs are active by default. For further information, refer to section
‘
Audio Settings
’
.
2 Audio Outputs

1 output (line level) via RCA connector providing audio from far end in addition to dial
tones. This output is used by the monitor. This output also supports S/PDIF.

1 VCR output (line level) via RCA connector providing a mixed signal between audio
from the local side (except from the VCR input) and audio from the far end. This
output is intended for connection to a VCR.