Ultratec 4425 - Manual (Page 20)

18 • SET-UP
About the printer +
The printer is on when you turn on your Superprint 4425 for the
first time. Press the print key (
+ ) to turn off the printer.
The display says PRINTER OFF. Press the print key again to turn
the printer back on. You can turn the printer on or off at any
time, including during a call.
The printer starts a new line after 24 characters are typed. If a
word is too long to fit at the end of a line, the printer divides it
with a dash. You can also start a new line yourself by pressing the
key. Often the last line will not be printed at the end of a
conversation unless you press the key before you turn off
the machine.
Setting the print case +
The Superprint 4425 prints everything you type in lowercase
(small) letters and everything the other person types in uppercase
(CAPITAL) letters. You can change this setting so that everything
is printed in uppercase letters by following these steps:
1. Press the options key ( + ). The display says PRINT
(UP/LOW) CASE.
2. Press the to change the setting to UPPER.
3. Press the key to save the setting and leave the options.
This option stays changed until you change it again or you reset
the Superprint 4425.
Setting the print size +
Your Superprint 4425 is set to print 24 characters on each line
(normal). You can change this setting and print 19 characters
(bold) or 14 characters (wide) per line. Follow these steps to
change the print size:
1. Press the options key ( + ). You will see PRINT
(UP/LOW) CASE on the display.
9 Ctrl
9 Ctrl
Esc
S p a c e b a r
9 Ctrl
9 Ctrl
Return
Return
3 Ctrl
3 Ctrl