Ultratec 4425 - Manual (Page 45)

AUTO-ANSWER • 43
4. Press the key to
clear your auto-
answer messages.
Press the
key if
you decide not to
clear them.
Hold down the key and the key to read messages at normal
speed. Keep holding down the key but let go of the key to
go faster. Hold down the key again to return to normal speed.
Hold down the key and the key to read back through
messages.
If you do not want to read messages when you turn off auto-answer,
you can do so later. Messages stay in memory until you clear them.
The Superprint 4425 will ask again if you want to read messages the
next time you turn off auto-answer.
Changing the contents of the pre p ro -
grammed auto-answer memo
+
You can change what the p re - p ro grammed auto-answer memo says
by following these steps:
1. Press the memo key ( + ). You will see EDIT MEMO on
the display.
2. Type ANSWER and press the key to tell the Superprint
4425 that you want to edit the memo named “Answer.”
3. Press the clear key ( + ). You will see CLEAR CONTENTS
Y/N on the display.
4. Press the key to erase the contents of the memo.
5. Type the new message you want to send as your outgoing auto-
answer message.
6. Press the key to save the new message. Esc
Y
8 Ctrl
Return
6 Ctrl
6 Ctrl
Shift
Shift
Shift
N
Y