Ultratec PRO80TM - Manual (Page 15)

S E T U P • 9
INSTALLING PRINTER PAPER
The printer uses high-quality thermal paper. Use the order card that
comes with the TTY to order more paper. If you do not have the card,
contact your dealer or Ultratec (the address is on the inside front cover of
this manual).
1.
Take off the printer cover by lifting the back edge of the cover up
toward the keyboard then lifting the cover off. A new unit may not
have the cover installed, in which case you will find it elsewhere
inside the box.
2. With the paper coming off the bottom of the roll, facing the back of
the Superprint Pro80, feed the edge of the paper into the slot on the
back until it stops.
3. Turn the Superprint Pro80 on, then press the key several times
until the rollers grab the paper and feed it through the printer.
4. Feed the paper through the slot in the printer cover and replace the
printer cover.
5. The two open ends of the paper holder fit
into the holes on each side of the paper
roll. Pull the two ends apart in order to
fit the paper roll between them. The
spring action of the holder will keep the
paper on it. You may need to remove the
paper holder from the Superprint Pro80
in order to install the roll of paper. To
replace the paper holder, snap it back
onto the bottom of the TTY.
Enter
Before Loading
Paper:
First, notice how the
paper holder is
installed. This holder
may come off while
loading the paper.
Second, connect the
power and phone line
before attempting to
load the paper (see
“Connecting Power &
Phone Line” on page 7).
When opening a
new roll of paper.
New rolls of paper may
may have some glue on
the first few inches.
This glue, which helps
keep the paper rolled
during shipment, can
interfere with printing.
Make sure paper that
has glue on it is fed
past the printer and is
not used for printing.
Put the paper on the metal
holder and snap the holder
onto the bottom of the
Superprint Pro80.
Feed the paper through the
slot in the printer cover. Put
the cover back on.
With the paper coming
off the bottom of the
roll, facing the back of
the Superprint Pro80,
feed the edge of the
paper into the slot on
the back until it stops.
Turn on the Superprint Pro80
and press the key sev-
eral times until the rollers
grab the paper and feed it
through the printer.
Enter
Take off the printer
cover: Lift the back
edge up toward the
keyboard.Then, lift the
cover off.
Paper Holder