Xilinx LogiCore PLB PCI Full Bridge - Manual (Page 41)

PLB PCI Full Bridge (v1.00a)
DS508 March 21, 2006 www.xilinx.com 41
Product Specification
EAR
LY
ACCESS
PCI Initiator Initiates a Read Request of a PLB Slave
This section discusses the operation of a remote PCI initiator asserting both single and multiple read
commands to read data from a remote PLB slave. For these transactions, the v3.0 core is the PCI target.
Because all PLB address space must be memory space in the PCI sense, memory read, memory read
multiple and memory read line are the only read commands from a remote PCI initiator that the PLB
PCI Bridge will respond to. The I/O read command will be ignored and the configuration read
command will be responded to by the v3.0 core, but has limited impact on the PLB PCI Bridge.
The PLB PCI Bridge determines if the PCI read command is translated to a PLB read as a burst or a
single read operation based on the PCI command asserted by the PCI initiator.
Table 16 shows
translations of PCI commands to PLB transactions. During an execution of PCI read commands, a PLB
rearbitrate from a remote PLB slave is translated to a PCI retry. Only one PCI initiator read of a PLB
slave is supported at a time.
For memory read commands (i.e., not memory read multiple), the address presented on the PCI is
translated to the PLB address space by high-order bit substitution with the 2 lsbs set as defined by the
byte enable vector for the first data phase. The lsbs are set to the lowest address of the byte lane asserted
in the byte enable vector as required by the Xilinx PLB specification. Byte enables from the PCI bus are
passed correctly to the PLB in single PLB read transactions. For memory read multiple read commands,
the address presented on the PLB is double word aligned.
Every memory read multiple command that translates to a burst read operation is performed with the
full 64 bits on the PLB independent of the byte enable specified by the PCI initiator. The byte enable bits
asserted by the PCI initiator in memory read multiple operations of an PLB slave are ignored, and all
byte are read during the PLB burst read operation per PLB protocol. Hence, dynamic byte enable is not
supported by PCI initiator burst read from PLB slaves. The system designer must insure that a burst
read with all byte enables asserted is not destructive. The user must insure that corrupting the fidelity
of the PCI read command with arbitrary byte enables asserted by translating to a PLB burst with all
byte enable asserted is not destructive.
Latency timer
expiration N/A because v3.0 core waits for one
transfer after timeout occurs
Automatically retried a parameterized number of
times. If the last of the PCI write command retries
fails due to a Latency Timer expiration, the PLB
Master Burst Write Retry Timeout interrupt is
asserted. The PLB master must reissue command
per PCI spec if last termination was a retry.
Target Abort
Assert PLB Master Write Target Abort
interrupt
Assert PLB Master Write Target Abort interrupt. If
the burst write is still in progress, Sl_MErr is
asserted with Sl_wrDAck.
Remote PLB
master bursts
data beyond
valid address
range
N/A
The PLB PCI Bridge will not accept the data and a
PLB IPIF timeout will occur for each double word
buffered in the IPIF. Because the write is posted,
the PLB transaction has completed on the PLB
and Slv_MErr is not asserted. After the last
timeout occurs and the last valid data is
transferred successfully to the PCI target, the
bridge is available for a new write transaction.
Table 18: Response of PLB Master/v3.0 Initiator write to a remote PCI target with abnormal condition on
PCI bus (Contd)