SENA Rhio10 - Manual (Page 15)

15
Figure 2.7 Rhio Manager screen layout
2.3.2 Basic configuration using Rhio Manager
Select Interface
It specifies the communication method between Rhio10 and Rhi0 Manager. Be sure to set it up
as “Network” mode.
Quick Connect
Users may connect to the Rhio10 from using Rhio Manager by specifying the destination IP
address. Once users click [Quick Connect] button, then Rhio10 detected is shown on the Probe
screen as a tree structure form. If users click the one, then they will be asked to enter the ID
and Password. The Rhio10 parameters are displayed on the Get/Set screen with correct ID and
password (Factory default ID:PASSWORD is admin : admin.)
Figure 2.8 Quick connect dialog box