SENA Rhio10 - Manual (Page 31)

31
Figure 3-9 System Administration Configuration
3.4 Restoring Factory Default
Users may restore the Rhio10 parameters into factory default value by pressing factory reset
switch on the hole of Rhio10 side panel. They will have to put the sharp pin into the hole and
press it for around 1 sec to reset the Rhio10. Rhio10 will be rebooted after the operation.
The following is the factory default value of the parameters.
IP Mode: DHCP
Host Mode: TCP Server, TCP port 6001
ID / Password: admin / admin
Device Name: Rhio10 Device
I/O Port status: Enable
Power-out Post Recovery: Enable
ADC Operation Mode : Level Mode
ADC Threshold value : 512
Output Port operation condition : None
Run/Stop status : Run