SENA Rhio10 - Manual (Page 70)

70
2) The user has to log into the RHIO10. Type the user name and password. A factory default
setting of the user name and password are both admin.
3) If the user logged into the RHIO10 successfully, the same command prompt screen as the
one of serial console will be displayed. The user can set, get, save configuration parameters
and exit console, reboot the device as like the serial console.
4) If serial console or the other remote consoles are connected already, new console will not be
established at all.
B.2 Command Usage
The RHIO10 provides several simple commands for configuration and control of the RHIO10.
Table B-1 summarizes command set which RHIO10 supports.
Table B-1 RHIO10 command set summary
Command Description Result
set group par1 [par2 ...] +
<CR>
Set configuration parameters
- group = 'ip', 'host', 'serial' or 'admin'
- par1 ... = configuration parameters. Use * to
keep a parameter's value
If success,
“OK” + <CR> + <LF>
If error
“ERROR” + <CR> +
<LF>
get [group] + <CR> Get configuration parameter values
- group = 'ip', 'host', 'serial', 'admin' or 'status'
- If group is specified, shows settings of the
group.
- If group is omitted, shows settings of all
groups.
Parameter value display
help [group] + <CR> Shows command usage screen.
- If group is omitted, shows help screen.
- If group is specified, shows 'set' command
usage of the group.
Help message display
factorydefault [option] + <CR> Restore factory default values
- if option is omitted, all parameters are set
with factory default values.
If success,
“OK” + <CR> + <LF>
If error