SENA Rhio10 - Manual (Page 69)

69
- Save changes
exit + <CR>
- Exit without rebooting the device
reboot + <CR>
- Exit and reboot the device
>
Figure B-3. The RHIO10 console screen
From the command prompt screen, users can set, get and save configuration parameter values
using ‘set’, ‘get’ and ‘save’ command. Users also can exit the console or reboot the device using
‘exit” and ‘reboot’ command. The usage of the commands can be found using ‘help’ command.
For command usages description, please refer to section B.2 Command usage.
B.1.2 Using Remote Console
The RHIO10 provides remote console feature via telnet as well as serial console so that users
can access the RHIO10 at remote site for configuration and monitoring purpose. The IP address
of the RHIO10 must be known before users can access the remote console port. The port
number for the remote console is 23, which is a TCP port number assigned for Telnet.
Only one user can log into the remote console or serial console at a time. If the serial console is
established while a remote console is established, current remote console will be halted and no
more remote console will be established until serial console is finished.
To access remote console of the RHIO10, please use the step as follows:
1) Run a telnet program or a program that supports telnet functions such as TeraTerm-Pro or
HyperTerminal. The target IP address and the port number should be those of the RHIO10.
If required, specify the port number as 23.
Type the following command in the command line interface of your computer.
telnet 192.168.1.254
Or run a telnet program with parameters as follows.
Figure B-4 Telnet program set up example