SENA Rhio10 - Manual (Page 75)

75
B.2.4 'save' Command
With ‘save’ command, current parameter changes are saved to non-volatile memory. Command
usage of ‘save’ command is as follows:
save + <CR>
Saved changes will be applied if the RHIO10 is rebooted by ‘reboot’ command or manual
rebooting.
B.2.5 'exit' Command
With ‘exit’ command, current serial or remote console session will be closed. However, changed
parameters are not applied until the RHIO10 is manually rebooted. Command usage of ‘exit’
command is as follows:
exit + <CR>
B.2.6 'reboot' Command
With ‘reboot’ command, the RHIO10 will be rebooted immediately. Changed parameter values
will be applied when the RHIO10 is up again. Command usage of ‘reboot’ is as follows:
reboot + <CR>
B.3 System Configuration using Console command
B.3.1 Network Configuration
Basic ‘set’ command usage for IP configuration is as follows:
set ip ipmode par1 par2 ...
where,
ipmode: ‘static’ for Static IP / ‘dhcp’ for DHCP / ‘pppoe’ for PPPoE
parameters: