SENA Promi-MSP User Guide User Manual
Page 16
16
Copyright © 2006 Sena Technologies, Inc. All rights reserved.
Then you will get following screen:
Place the MSP upgrade ROM file which is downloaded from SENA web site to
C:\ folder on your PC and run tftp command on [Start] →[Run] as below.
Users need to make sure that the upgrade ROM file is in the same location or users
need to specify the exact location to send the ROM file to the connected Promi-MSP
via crossed ethernet cable.
Below
window
is
showing
the
procedure
of
sending
ROM
file
named
“msp2_040906.rom” to the connected Promi-MSP via TFTP.
Users will be able to check the status of firmware upgrade in Serial console.
During upgrade, LEDs will flash and users SHOULD NOT turn off Promi-MSP this time.
If user cannot send the ROM file, please check the network connection status.