SENA Promi-MSP User Guide - Manual (Page 41)

41
Copyright © 2006 Sena Technologies, Inc. All rights reserved.
Baudrate 1200 ~ 115200 bps
Character size 5,6,7,8 bit
Parity None, Odd, Even
Stop bit 1 bit, 2 bits
Flow Control None, XOn/Off, Hardware (CTS,RTS)
DTR/DSR not used
RI not used
Auto probe not supported
As default, RS232 interface of Promi-MSP is configured for configuration console. In order to
use RS232 interface for the data communication purpose, user needs to change the Console
switch to data mode. Changes will be effective after power-c ycling of Promi-MSP. Please restart
Promi-MSP.
AT Commands
AT command is very familiar with the legacy serial application developers. So, AT command
interface of Promi-SD eases a lot of efforts to develop their own application from developers. So
does Promi-MSP. Moreover, AT commands of Promi-MSP are so similar to one of Promi-SD that
developers who have experiences with Promi-SD can make use of multi-serial functionality in
no time.
By default, AT command parser is disabled. You can enable AT command feature on
configuration console as below.