At command interface – SENA Promi-MSP User Guide User Manual
Page 57
57
Copyright © 2006 Sena Technologies, Inc. All rights reserved.
6. AT Command Interface
Promi-MSP supports user friendly AT commands. Make sure this feature enabled in
configuration console in order to use AT commands.
Most of them are compatible with Promi-SD but some have differences in their usage and some
commands are appended for Promi-MSP exclusive use.
Supported AT commands and their differences from AT command of Promi-SD are summarized
as below. Please refer to Promi-SD userguide for more information.
Command
Description
Example
AT
compatible with Promi-SD
ATZ
〃
AT&F
〃
ATD
Connectable up to 7 devices concurrently
ATH
Device to disconnect can be specified.
ath000b53123456<cr>
ATO
Device to communicate can be specified.
Without
specified
device,
lately
communicated device will be selected.
ato000b53123456<cr>
CONNECT 000B53123456