SENA Promi-MSP User Guide - Manual (Page 18)

18
Copyright © 2006 Sena Technologies, Inc. All rights reserved.
<Upgrade firmware via Xmodem>
2.4 Serial Port
Serial port of Promi-MSP can be used for both Configuration and Data communication. For this,
users need to change the DIP switch of Promi-MSP to the right.
Note:
Before to configure the serial port settings, please change the DIP switch to the right.
Users may set configuration of serial port communication in this menu.
Below figure is showing that ‘115200 bps 8-N-1 hardware’which means ‘115200 bps, 8 data bit,
None parity, 1 stop bit, hardware flow control (RTS/CTS).