SENA Promi-MSP User Guide - Manual (Page 21)

21
Copyright © 2006 Sena Technologies, Inc. All rights reserved.
3. Configuration
If users finished configuring network settings using serial console, now users need to select the
operation mode of Promi-MSP. Following three (3) ways can be used for selection of operation
mode:
1. Via Promi-MSP configuration software
2. Via Telnet (Control port)
3. Via Web browser (Internet Explorer, etc.)
In this chapter, guide to use Promi-MSP configuration software will be introduced.
How to configure via Telnet or Web browser will be introduced in Appendix.
3.1 Configuration via Promi-MSP software
3.1.1 When Promi-MSP is connected to PC directly
If users are going to connect Host PC and Promi-MSP directly using a crossed
cable, network settings as in the chapter 2.1 will not be required.
Promi-MSP has factory settings: Static IP 192.168.1.10/24 with DHCP server
For communication with Promi-MSP, just connect Promi-MSP and Host PC with a
crossed cable as below. Make sure Host PC to be configured using DHCP.
3.1.2 Log in Promi-MSP software
For easier configuration and monitoring on a specific Promi-MSP, which has been